Jts315La - Jet JTS-315LA Operating Instructions Manual

Test Report No.: No.: 17706687 001
Part II of II
Requirement  Test
Clause
method and may be used for comparing one tool
with another;
- that the declared vibration total value may also
be used in a preliminary assessment of exposure.
5 A warning:
- that the vibration emission during actual use of
the power tool can differ from the declared total
value depending on the ways in which the tool is
used; and
- of the need to identify safety measures^ protect
the operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when
it is running idle in addition to the trigger time).
8 PROTECTION AGAINST ELECTRICAL SHOCK
8.1 Protection against accidental contact of live parts
and parts with basic insulation or live parts for class
II equipment
User removable parts (with and without tools)
Openings in enclosure
Apertures in class II and class I tools
Use of test pin and finger behind removable parts
Apertures preventing the entry of the test finger
Live parts protected by lacquer, enamel etc.
Access to parts of class II equipment
Introduction or removing of bulbs
8.2 Mechanical strength on parts providing protection
against electrical shock
8.3 Shafts of operating knobs, handles, levers and the
like
8.4 Handles or knobs of switching means of metal
8.5 Capacitor in class II equipment
Metal casing of capacitor to accessible live parts
8.6 Risk of electric shock from stored charge on
capacitors connected to mains circuit
Capacitor with rated capacitance not exceeding
0,1uF
Page 14 of 63
EN 61029-1:2009+A11
Result - Remark
Checked and found
satisfactory
Class I
No bulbs
See clause 19
None
None
class I
Verdict
N/A
P
P
P
P
P
P
P
P
N/A
N/A
P
N/A
N/A
N/A
N/A
P
P