Mounting The Raving Knife; Mounting The Saw Guard; Rising And Tilting Sawblade; Rip Fence Setup - Jet JTS-315LA Operating Instructions Manual

Fig 14
Order for installation: Fig. 14
-Blade set screw (02)
-Centring flange (04)
-Saw blade (K)
-Tightening flange (03)
Refit and set the splitter (F) and the
saw blade guard(A). Fig.1
Check to make sure that all safety
devices are properly mounted and in
good working condition before you
begin working with the saw again.

7.2 Mounting the raving knife

The supplied raving knife must always
be used.
Disconnect saw from power source,
unplug!
The raving knife (F, Fig 15) is
clamped with 1 nut (U).
Fig 15
Adjust the space between sawblade
teeth and raving knife to be 2 to 5mm.
Well tighten the locking nut (U).

7.3 Mounting the saw guard

The saw guard must always be used.
Attach the saw guard (A, Fig 16) to
the raving knife (F) with 1 carriage
bolt, washer and wing nut
Fig 16
The saw guard must be lowered to
the work piece to minimise the
amount of exposed teeth.
7.4 Rising and tilting of sawblade
Setup adjustments of the sawblade
shall never be performed when the
machine is running.
Use the front handle (I, Fig 1)to raise
the sawblade.
Use the tilting handle (H, Fig 1) to tilt
the sawblade. Tighten knob to lock in
place.
Start the machine with care.

7.5 Rip fence setup

Rip fence setup shall never be
performed when the machine is
running.
Use 2 bots and wing nuts (f, Fig 17,
Fig. 18) to attach the aluminium
profile (e) to the rip fence body
17
Note:
The rip fence profile can be placed
flat and adjusted in length.
-Use in upright position (Fig 17) for
cutting wide stock:
-The cutting of small workpieces
(width less than 120mm) and tilted
cuts shall only be performed with the
rip fence profile placed flat (Fig 18).
Start the machine with care.
7.6 Adjusting 90°stop
The positive stop is adjusted at the
factory.
If out of alignment:
Disconnect saw from the power
source, unplug.
Readjust the positive 90° stop.

7.7 Adjusting sawblade parallel

The sawblade is adjusted parallel to
the machine table at the factory.
If out of alignment:
Disconnect saw from the power
source, unplug.
Loosen the screws on the tabletop (V,
Fig 19) and readjust saw unit.

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
Fig
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Consult a qualified repair shop if a
malfunction or damage occurs to this
tool, including sawblades and guards.
Cleaning:
Clean the machine regularly.
Inspect the proper function of the dust
extraction daily.
Keep the inside of the cabinet clear of
sawdust and wood chips.
Fig 18
Fig
19