Jts315La - Jet JTS-315LA Operating Instructions Manual

Test Report No.: No.: 17706687 001
Part II of II
Requirement  Test
Clause
type as specified in these instructions,
Replacement of the plug or the supply cord
-
shall always be carried out by the
manufacturer of the tool or his service
organization,
- Keep water clear off the electrical parts of the
tool and away from persons in the working
area.
The following information shall also be given:
the business name and address of the
-
manufacturer and, where applicable, his
authorised representative. Any address shall
be sufficient to ensure contact;
the designation of the tool and series or type
-
as required by 7.1, including description of
machine such as "bench grinder", "band saw"
etc;
- a repeat of the safety markings (e.g.
maximum speed, capacity, etc.) that are to be
marked on the tool;
an explanation of any symbols or pictograms
-
marked on the tool;
the mass of the tool including detachable
-
parts.
Emissions:
1 The noise emission measured in accordance
with 13.2, as follows:
A-weighted sound pressure level L
-
uncertainty K
Where L
fact shall be indicated;
- A-weighted sound power level L
uncertainty K
pressure level L
peak C-weighted instantaneous sound
-
pressure value L
K
pCpeak
relation to 20 µPa).
2 Recommendation for the operator to wear
hearing protection.
3 The vibration total value and its uncertainty
measured in accordance with 13.3.
When the vibration total value does not exceed
2
2,5 m/s , this shall be stated.
When the vibration total value exceeds 22,5 m/s
its value shall be given in the instructions.
4 The following information:
- that the declared-vibration total value has been
measured in accordance with a standard test
EN 61029-1:2009+A11
where L exceeds,70 dB(A).
pA pA
does not exceed 70 dB(A), this
pA
, where the A-weighted sound
wA
exceeds 80 dB(A);
pA
and its uncertainty
pCpeak
, where this exceeds 63 Pa (130 dB in
Page 13 of 63
Result - Remark
Checked ok
Checked ok
and its
pA
and its
wA
2
,
Verdict
P
P
P
N/A
N/A