Jts315La - Jet JTS-315LA Operating Instructions Manual

Test Report No.: No.: 17706687 001
Part II of II
Requirement  Test
Clause
19.1 Mechanical strength under normal use condition
19.2 Blows on outer surfaces with impact hammer
19.3 Mechanical strength of brush-holders and their
caps
20 CONSTRUCTION
20.1 Class I, class II or class III construction
20.2 Accidental changing of voltage setting
20.3 Accidental changing of control devices
20.4 IP degree and removal of parts
20.5 Handles, knobs and the like indicating switch
positions
20.6 Replaceable components
20.7 Replaceable flexible cord
20.8 Use of wood, cotton, silk, ordinary paper or
hygroskopical materials as insulation
Asbestos
Driving belts
20.9 Use of reinforced insulation
20.10 Insulation barrier of class II tools serving as
reinforced insulation
20.11 Assembly gap in supplementary insulation
20.12 Construction requirements
Loose of wires, screws, nuts, spring or similar parts
in class I tools
Loose of wires, screws, nuts, spring or similar parts
in class II tools
Class II tools other than all-insulated type
20.13 Requirements to supplementary and reinforced
insulation
Insulation impaired by deposition of dirt and dust
Synthetic rubber used as supplementary insulation
in class II tools
Page 31 of 63
EN 61029-1:2009+A11
Result - Remark
3 blows with energy of 1Nm are
respectively applied on saw
blade top guard, switch box,
capacitor box, dust chute, and
motor fan cover.
Class I
Found satisfactory
No this kind of material used as
insulation.
Not used
Class I
See below
Class I
Class I
Class I
Verdict
P
P
N/A
P
P
N/A
N/A
P
N/A
P
N/A
P
P
N/A
P
N/A
P
P
P
N/A
N/A
P
P
N/A