Before driving a new tractor, first get acquainted with the gear shifting scheme and try out individual
positions of gear shifting lever with engine at standstill.
Before you drive off in normal operation you must make sure that technical condition corresponds with the
conditions of safe operation.
General principles of new tractor run-in in first 100 hours of operation
During first 100 hours of operation:
Load tractor in a normal way, avoid operation with
low or maximum engine revolutions
Avoid operation under partial loading of the engine
Avoid excessive idle run operation
Check oil levels in engine often (during this time
increased oil consumption is normal)
Check screw joints in particular in supporting parts
of tractor
Learned insufficiencies to be removed immediately,
you will thus prevent subsequent damage or
endangered operation
Keep the same procedure also after tractor
complete overhaul
In first 10 hours of operation
perform run-in in traffic
tighten fastening nuts of front and rear wheels
including connectionbead / rim with prescribed
torque
From 100 hours of operation
After drive in completion you can work with tractor without
limitations.
Recommended
1,400 - 2,300
operation
rpm
revolutions
Idle run revolutions 900 rpm
Oil pressure with
min. 0,14 MPa
idle run revolutions
Max. coolant
110°C
temperature
RUNNING IN THE TRACTOR
47
NM13N100
E256