Ual Positions Of The Shifting Lever Setting In Motion With The Automatic Function; Changing The Driving Direction - Using The Clutch Pedal; In Normal Operation, Before You Changing The Driving Direction With The Automatic Function - Zetor PROXIMA POWER Z90 2012 Operator's Manual

SETTING IN MOTION WITH THE
AUTOMATIC FUNCTION
The automatic function consists in shift-
ing the reversing lever with a suitable
gear engaged and subsequent putting
the tractor in motion without using the
clutch pedal or clutch control button.
1. Start the engine
2. Select the suitable gear for putting
the tractor in motion.
3. Release the parking brake. If you
are standing on a slope, hold the
tractor with the foot brake.
4. When you shift the reversing lever
from the neutral position to the re-
quired driving direction of the tractor
(forward or reverse) the tractor will
start moving.
5. Release the foot brake completely
while simultaneously increasing the
engine speed.
When you depress the clutch
pedal, the automatic function is
deactivated.
CHANGING THE DRIVING DIRECTION
- USING THE CLUTCH PEDAL
1. Depress the clutch pedal and brake
the tractor with the foot brake.
2. Shift the reversing lever to the re-
quired driving direction of the tractor.
DRIVING OPERATION
3. Release the clutch pedal until the
travel engagement point and while
simultaneously increasing the en-
gine speed continue releasing the
clutch pedal smoothly.
4. Start moving smoothly and slowly.
CHANGING THE DRIVING DIRECTION
WITH THE AUTOMATIC FUNCTION
You can change the driving di-
rection with the use of the auto-
matic function at a driving speed
lower than 10 km/h. If you try to
change the driving direction at a
higher speed than 10 km/h, the
acoustic signal will sound (con-
tinuous tone). The signal will be
switched off when you shift the
lever back to the N position or af-
ter depressing of the clutch
pedal.
1. With the use of the brake pedals re-
duce the tractor speed below 10
km/h.
2. Shift the reversing lever to the re-
quired driving direction of the tractor.
3. The tractor will stop automatically
and start moving in the requested di-
rection.
If the tractor speed does not drop
below 10 km/h, the tractor will
shift into neutral and it will be
74
necessary to decrease the tractor speed
below 10 km/h, shift the reversing lever
to the neutral position and repeat the
shift to the requested direction.
4. While simultaneously increasing the
engine speed continue putting the
tractor in motion smoothly.
When you depress the clutch
pedal, the automatic function is
deactivated.
If you perform the above men-
tioned activity after an attempt to
change the driving direction at a
speed over 10 km/h, you must
reduce the travelling speed of the
tractor below this speed. Other-
wise, after releasing of the clutch
pedal the neutral gear will still be
shifted.