Switching Of The Rear Pto Shaft; Pto Shaft Revolutions 540 And 1000 Rpm Shifting Lever - Zetor MAJOR HS Series Operator's Manual

Switching of the rear PTO shaft

Switching on and off of the rear PTO shaft is performed with the switch (1) located in the area on the right
rear mudguard.
If the situation permits, engage the clutch of the PTO shaft with min. engine revolutions of 1,500 rpm.
Activation of the switch (1) is indicated by the red backlight of the Pto (2) symbol on the display of the
instrument panel.
The switch is equipped with a mechanical lock (3) against accidental switching. To switch the switch, press
the lock (3) in the direction of the arrow and then press the switch.
Do not activate the clutch switch (1) of the rear PTO shaft for dependent geared PTO
revolutions!
Rear output shaft - shifting of dependent and independent speed of the shaft
The rear PTO shaft is activated with the lever (1) located on the right left of the driver's seat.
a - dependent revolutions of the PTO shaft drive through the gearbox -
revolutions are dependent on the shifted gear
n - neutral position
b - independent revolutions of the PTO shaft drive - revolutions are dependent
on the engine revolutions
Shifting is performed when the tractor is idling and when the PTO clutch is deactivated.
The lever (1) shifted in the position (a) dependent revolutions is indicated by the red backlight of the PtoG (2)
symbol on the display of the instrument panel.
The lever (1) shifted in the position (a) independent revolutions is indicated by the red backlight of the PtoD
(3) symbol on the display of the instrument panel.
DRIVE OF AGRICULTURAL MACHINERY
MHS16N109
MHS16N110
66