Control Of Front Driving Axle; Driving With Front Drive Axle Engaged; Foot Brakes - Zetor MAJOR HS Series Operator's Manual

Control of front driving axle

The front drive axle is activated by the switch on the
steering column. Switching of the front driving axle is
indicated with the activated symbol on the switch.
The drive of the front axle can be activated while the
vehicle is in motion under the load without the use of the
clutch pedal.
Note: For driving along the land road and in the case of
higher speeds switch off the drive of the front axle.

Driving with front drive axle engaged

Permanent engagement of front drive axle is admissible; if
front mounted agriculture machine or tool is connected.
This condition is given in operation manual of the
applicable machine.
Maximum permitted speed of these sets is 15 km/h.
Use front drive axle with slip of rear wheels to increase pull of tractor. On the road and on hard
surface causes driving with front drive axle engaged increased tire wear of front wheels.

Foot brakes

Foot brakes are disk brakes, wet brakes, hydraulically
controlled and double pedal with automatic pressure
equalization. When driving on the road, both pedals must
be connected with a latch. Disconnected pedals for
braking of the right or left wheel should be used during
field work only.
A - disconnected pedals
B - pedals connected with a latch
Note: When driving down the steep slope with a trailer or
semitrailer equipped with air or hydraulic brakes you must
use the foot brake even from the beginning of the slope!
During braking with one brake pedal, the brakes of the trailer are not operating!
DRIVING OPERATION
55
MHS16N064
C220
NM15N001