If Engine Does Not Start; Manipulation With Starter; Immediately After Start - Zetor MAJOR HS Series Operator's Manual

If engine does not start

Return the key to position '0', wait 30 seconds and repeat
the start.
A maximum of 6 starting cycles is allowed (15 seconds
start and 30 seconds interruption is one cycle). Another
engine start is allowed after the starter cools off to
surrounding temperature.
Never help a stopping tractor with a starter. There is a danger of starter damage .

Manipulation with starter

It is forbidden to start by short circuiting starter
clamps! Tractor is started only from driver's seat!
With any manipulation or starter repair it is necessary
to disconnect minus battery pole and all shifting
levers including PTO shaft shifting lever must be in
neutral position!
Starter contacts are covered with a cap.

Immediately after start

Check greasing, charging and other functions ensuring proper engine operation (controls must go out) in this
time. The time of engine operation without load must be observed, in particular in winter period.
After starting, set revolutions to 800 - 1,000 rpm and let engine run without load for a period of
app. 2 minutes.
DRIVING OPERATION
48
NM13N091
NM13N093