Configuring The Interface Module; Assignment Of The F-Destination Address For Fail-Safe Modules - Siemens SIMATIC ET 200SP System Manual

6.3

Configuring the interface module

Configuring
Read the STEP 7 online help and/or the documentation of the configuration software
manufacturer when configuring the interface module.
6.4

Assignment of the F-destination address for fail-safe modules

The F-destination address is saved permanently on the coding element of the ET 200SP fail-
safe modules.
Note
The supply voltage L+ must be applied to the F-module when the F-destination address is
assigned.
Note
Note the following in conjunction with configuration control:
Before you can use configuration control together with F-modules, you must assign the F-
destination address to the F-modules at the designated slots. For this, each F-module must
be inserted in the slot configured for it. The actual configuration can then differ from the
specified configuration.
For additional information on assigning the F-destination address, refer to the SIMATIC
Safety - Configuring and Programming
(http://support.automation.siemens.com/WW/view/en/54110126) Programming and
Operating Manual and to the online help for the
Distributed I/O system
System Manual, 12/2015, A5E03576849-AF
6.3 Configuring the interface module
S7 Configuration Pack
.
Configuring
119