Siemens SIMATIC ET 200SP System Manual page 65

Procedure
Watch the video sequence (http://support.automation.siemens.com/WW/view/en/95886218)
To connect the cable shield, follow these steps:
1. If necessary, connect the supply voltage L+ and ground to the BaseUnit.
2. Press the shield contact up into the mount until you hear it click into place.
3. Remove the cable insulation material around the shield terminal.
Connect the cable to the BaseUnit and place the cable in the shield contact.
4. Insert the shield terminal into the shield contact.
5. Tighten the shield terminal with approximately 0.5 Nm.
①
②
③
④
Figure 5-7
Distributed I/O system
System Manual, 12/2015, A5E03576849-AF
Mount
Supply voltage L+, ground
Shield contact
Flat connector for push-on contacts
(6.3 × 0.8 mm)
Mounting the shield contact
5.7 Connecting cable shields
⑤
Insulation material removed (approx. 20
mm)
⑥
Cable to the encoder
⑦
Shield terminal
Wiring
65