Wiring
5.11 Labeling ET 200SP
5.11.4
Applying labeling strips
Procedure
Watch the video sequence (http://support.automation.siemens.com/WW/view/en/95886218)
Proceed as follows to install a labeling strip:
1. Label the strips.
2. Insert the labeling strip into the interface module or I/O module.
5.11.5
Applying reference identification labels
Procedure
Watch the video sequence (http://support.automation.siemens.com/WW/view/en/95886218)
Proceed as follows to install a reference identification label:
1. Break off the reference identification labels from the sheet.
2. Insert the reference identification labels into the opening on the CPU/interface module,
BusAdapter, BaseUnit and I/O module. The opening is located on the top of the BaseUnit
or I/O module.
Note
Reference identification label
The printable side of the reference identification label must be facing forward.
①
②
Figure 5-33
96
Reference identification labels
Opening for label
Applying reference identification labels
Distributed I/O system
System Manual, 12/2015, A5E03576849-AF