Connecting Profinet Io To The Interface Module Via The Ba Scrj/Rj45 Busadapter - Siemens SIMATIC ET 200SP System Manual

5.9.4 Connecting PROFINET IO to the interface module via the BA SCRJ/RJ45
BusAdapter
Introduction
You connect PROFINET IO to the interface module via the BA SCRJ/RJ45 BusAdapter:
● Optically coupled to fiber-optic cables (FOC) with an SC RJ connector (port 1) or
● Electrically with a standard RJ45 connector (port 2)
To do this, screw the BA SCRJ/RJ45 BusAdapter onto the interface module and insert the
SC RJ connector or RJ45 plug.
You can loop through the PROFINET IO via the integrated 2-port switch. You can use any
port of the BusAdapter for feeding or for looping through. The integrated media converter
converts the signals automatically.
①
②
Figure 5-17
Attaching SC RJ connectors
You can find more information about the required tools, accessories, requirements and
procedures in the section Connecting PROFINET IO to an interface module via BA 2×SCRJ
BusAdapter (Page 74).
Connecting RJ45 plugs
You can find more information about the required tools, accessories and procedures in the
section Connecting PROFINET IO to an interface module via BA 2×RJ45 BusAdapter
(Page 68).
Distributed I/O system
System Manual, 12/2015, A5E03576849-AF
Fiber-optic cable SCRJ
RJ45
BA SCRJ/RJ45 BusAdapter
5.9 Connecting interfaces for communication
Wiring
77