Introduction; Sensica™ Uo System For Icu Instructions For Use, Model No. Sccs-1001, Ver - Adaptec Sensica UO Instructions For Use Manual

Sensica™ UO System for ICU Instructions for Use, Model No. SCCS-1001, ver. 1001

Introduction

This manual provides the indications, contraindications, warnings, precautions, and instructions for
use with the Sensica™ UO System for ICU. Carefully read this manual in its entirety before
using the Sensica UO System for ICU. Failure to follow these instructions may result in
improper use of this device. Contact Adaptec Medical Devices at (888) 441-1525 with any
questions about the information contained in this manual or about the operation and safety of the
Sensica UO System for ICU.
Both User and Administrator functionality of the Sensica UO System for ICU are described in this
manual:
Part I – Sensica™ UO System for ICU Overview, describes the basic functionality of the system
hardware, single patient use products, and user interface.
Part II – Sensica™ UO System for ICU Instructions for Use, contains information regarding the
proper procedures for operating the Sensica UO System for ICU.
Part III - Sensica™ UO System for ICU Care and Warranty, provides information on properly
maintaining and servicing of the system.
Part IV –Sensica™ UO System for ICU Administration, contains information regarding the initial
setup and administration of the system, along with the default settings.
Prior to initial use of the Sensica UO System for ICU, the Administrator should follow the
instructions in Part IV for proper device setup. Table 1 identifies the setup tasks an
Administrator can perform prior to first use of the device.
P/N 005-0175 Rev A Adaptec Medical Devices 7