Abb Abb Switzerland Ltd - ABB SYN 5201 Operating Instructions Manual

Operating Instructions
6.2 Fixing
Fit the device into the cut-out from the front. Snap the 2 fixing clips at the top and bottom
into the grooves (see diagram).
When fitting the fixing clips into the grooves, ensure that the threads are not subjected to
Caution
any mechanical loads.
Tighten screws evenly. Ensure that the front panel of the SYNCHROTACT 5 is flush
with the facing.
6.3 Earthing and wiring
The casing must be connected with the earth potential via the connection provided for
this purpose.
The use of shielded cables is not necessary. If shielded cables are nonetheless used for
protection against high-frequency interference, it is recommended that the shielding be
connected to the earth potential at both ends over as wide an area as possible. If it is
not possible to earth the cables at both ends, one of the following procedures can be
taken:

Earthing of the shielding via a capacitor. The shielding is earthed directly at one end
and via a capacitor at the other end.

Use of a double shielded cable: one of the two shields is earthed at one end, the
other at the other end.
6.4 Disposal
The inappropriate disposal of electrical equipment can lead to an environmental hazard.
It is therefore important that electrical equipment be disposed of by qualified personnel.
The metallic casing, cover and front frame do not present any environmental risk and
can be recycled.
The circuit boards must be removed and should be disposed by a licensed disposal
company. Environmentally harmful elements such as capacitors must be separated from
the circuit boards.
The SYNCHROTACT 5 devices are environmentally friendly designed. The circuit
boards are easy to remove.
abb
ABB Switzerland Ltd
Template: CHIND Techn doc stand, A4 P de, R1.DOT; Filename: 3BHS109762E01 D.doc; Print: 12/6/2011 5:48:00 PM; Save: 12/1/2011 2:37:00 PM; CHIND No. 3BHS109763 ZAB D14 Rev. -; I-Q
Document No Art Part
3BHS109762 E01
SYN 5201/SYN 5202
Language Revision page
en D 78