Parameter Set - ABB SYN 5201 Operating Instructions Manual

Operating Instructions
Faults
Code Description
072 Actuation of
SYNCHROTACT 5
defective
073 Internal fault: time
exceeding
074 Internal stabilised voltage
outside of tolerance
077 Channel 2 (SYN 5013)
hardware problem
(SYN 5202 only)
078 Internal fault
abb
ABB Switzerland Ltd
Template: CHIND Techn doc stand, A4 P de, R1.DOT; Filename: 3BHS109762E01 D.doc; Print: 12/6/2011 5:48:00 PM; Save: 12/1/2011 2:37:00 PM; CHIND No. 3BHS109763 ZAB D14 Rev. -; I-Q
Remarks
Fault appears after t tot:
Implausible combination
of control signals, or
signal missing (e.g.
parameter set selection
must take place  1 s
following start)
Internal transmission
fault: Parameter
memory or event logger
cannot be deleted or
written to.
Internal monitoring has
been tripped. Also
occurs if SYN 5012 is
missing

Data transmission to
channel 2 is defective

Wrong HW SYN 5013
is used (16 2/3 Hz)

Error in channel 2

Checksum error
during reading from
FlashPROM of
channel 1

SYN 5202: The
parameters of the
second channel
(SYN 5013) cannot
be read or written
Document No Art Part
3BHS109762 E01
SYN 5201/SYN 5202
Remedy

Check necessary signals

Check programming of the
configurable I/Os (A particular
parameter set may only be
selected by one input).

Try to cancel fault and observe
whether it reoccurs:
1. Cancel fault
2. Switch auxiliary voltage
on/off

Read out other events which
may have been displayed at
the same time. Try to identify
the fault on the basis of the
combination

Check whether the auxiliary
voltage is within the permitted
range (check return circuit !)

Switch auxiliary voltage off and
on again: if the fault is not
displayed again: OK

Error between SYN 5012 and
SYN 5013

Check the type
Checksum is checked after the
auxiliary power supply is
switched on:

Reset the error

Auxiliary power supply
OFF/ON

Read out the parameters and
check them or overwrite them
again
Language Revision
en
&
page
D 104