Abb Abb Switzerland Ltd - ABB SYN 5201 Operating Instructions Manual

Operating Instructions
It is practical to read the signals for the addresses 4 to 11 by polling, since otherwise the
Note
insufficient steadying of the measured values places a heavy load on the fieldbus (worst
case: a telegram every 20 ms). The measured value in Operating status is of the
greatest interest.
Address 13: The information is not generally of importance for transmission via the
Note
fieldbus, since the software in the device does not change.
Address 29 (Index 28):
Bit
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
4.3.6 Configuring Lon-Bus
The transmission rate is 1.5 MBaud.
Service key
The Service key is required for configuration. By pressing the key, the request for the
configuration data is sent to the master. The latter then sends the corresponding data to
the SYNCHROTACT slave.
The Service key is not required during normal operation.
abb
ABB Switzerland Ltd
Template: CHIND Techn doc stand, A4 P de, R1.DOT; Filename: 3BHS109762E01 D.doc; Print: 12/6/2011 5:48:00 PM; Save: 12/1/2011 2:37:00 PM; CHIND No. 3BHS109763 ZAB D14 Rev. -; I-Q
Binary signal
Start
Stop
Release DB
Reset (cancel fault and set to "READY")
--
--
--
--
configurable digital input 1 (only if SYN 5014 is used)
configurable digital input 2 (only if SYN 5014 is used)
configurable digital input 3 (only if SYN 5014 is used)
configurable digital input 4 (only if SYN 5014 is used)
configurable digital input 5 (only if SYN 5014 is used)
configurable digital input 6 (only if SYN 5014 is used)
configurable digital input 7 (only if SYN 5014 is used)
--
LWL-Anschluss
Document No Art Part
Service-Taster
3BHS109762 E01
SYN 5201/SYN 5202
LEDs
Language Revision page
en D 58