Side Support Packs - Arjohuntleigh RotoProne User Manual

2. Adjust foot support boards to provide proper foot positioning and help prevent foot drop.
The RotoProne Therapy System will accommodate patients up to approximately 6 ft 2 in tall with
the foot support boards in their lowest position.
• Determine appropriate position for patient's foot.
• Pull pin on top of foot support board assembly.
• Slide foot support board along rail into the desired position.
• Release pin to lock foot support board in position.
Do not remove both foot support boards simultaneously from contact with patient's feet, as patient may
migrate downward. Instead, alternate placement of the foot support boards.
3. Remove foot support boards.
The RotoProne Therapy System can accomodate patient's between
approximately 6 ft 2 in tall and 6 ft 6 in tall by removing the foot support
boards.
• To remove foot support board, pull pin located on the top of the foot support
board assembly.
• Slide the foot support board down and off the end of the rail.
• Place the appropriate size accessory pack between the foot and the end of the
Rotoprone Unit to help prevent skin breakdown and foot drop.
Place the label on the accessory pack away from the patient's skin. Ensure
patient's skin is not contacting any hard surface.
Check patient at regular intervals to ensure patient has not migrated downward in the
unit and come in contact with any hard surface.

Side Support Packs

1. Install side support packs:
• Extend patient's arm 90° to the side.
• Slide side support pack posts into side pack blocks and
position in between foot-end supports, as shown at
right.
Place end of support pack in between foot-end
supports, as needed, to accommodate width of
patient's torso and hips. For wider body types, place
pack end in between inside and middle support posts.
For narrower body types, place pack end in between
outside and middle support posts. Side packs should
be placed in the same position on each side.
3-13
Hip Pack
Thigh Pack
Shin Pack