Configuring Wifi Settings - HPE Edgeline EL300 Setup And Configuration Manual

• Enable this option if you want iSM to use IPv6 first.
• Disable this option if you want iSM to use IPv4 first.
If communication fails using the first protocol, iSM automatically tries the second protocol.
This option is enabled by default.
IPv6 Configuration
Enable IPv6 in Auto Mode
Enable this option to configure iSM to use an IPv6 DHCP server (if found). If no IPv6 DHCP server is available, IPv6
automatically falls back to using SLAAC. This option is enabled by default.
iSM creates its own link-local address even when this option is not enabled.
NOTE: Entering the command set network6 off at the Integrated System Manager CLI disables IPv6, and no IPv6
addresses can be used. The link-local address is disabled when IPv6 is disabled.
For more information about CLI commands, see the iSM Command Line Guide in the HPE Information Library at http://
www.hpe.com/info/EIL.
IPv6StaticAddress
When assigning static IPv6 addresses, enter the main IP address here.
IPv6StaticAddress PrefixLength
When assigning static IPv6 addresses, enter the prefix length here.
IPv6DefaultGateway
When assigning static IPv6 addresses, enter the default IPv6 gateway here.
DNS Configuration
When assigning static IPv6 addresses, enter the Primary, Secondary, and Tertiary DNS Server addresses.

Configuring WiFi settings

A WiFi connection presents an alternative when a wired connection is not feasible.
Prerequisites
iSM Admin privilege
Procedure
1. Click Wired and Wireless Network in the configuration tree, and then click the WiFi tab.
The iSM scans for WiFi signals and displays any SSIDs that are in range. The system will continue to scan until a SSID is
found.
2. Click a SSID.
The credentials page displays.
NOTE: Hewlett Packard Enterprise strongly recommends only connecting to secure networks.
3. Enter the password, and modify other settings as needed.
4. To activate the WiFi connection, select Enable.
Configuration 69