System Mount Options; Bracket Option Kits; Base Only Bracket Option Kit; Installing The Base Only Bracket Option - HPE Edgeline EL300 Setup And Configuration Manual

System mount options

The HPE Edgeline EL300 Converged Edge System requires to be mounted on a vertical surface. There are two mounting
options available for the system:
Wall mounting option
•
DIN rail mounting option
•
The EL300 system also supports bracket options that assist in the mounting of the system.
This chapter provides instructions for mounting the HPE Edgeline EL300 Converged Edge System.

Bracket option kits

The EL300 system supports two bracket option kits:
Base only bracket option
•
• Standard bracket option
Depending on the hardware configuration selected, any one of the bracket options can be installed on the HPE Edgeline
EL300 Converged Edge System.

Base only bracket option kit

The base only bracket option offers installation support for the EL300 base system only. This bracket option does not support
expansion unit installation.
The following components are available with the option kit:
• Base bracket panels (2)
• T-15 screws
• Cable management bracket
• Reusable cable ties and Velcro

Installing the base only bracket option

Prerequisites
Before you perform this procedure, make sure that you have the T-15 security screwdriver available.
Procedure
1. Place the system on a flat level surface.
2. Attach the brackets on the system:
a. Place the brackets on the side of the system.
b. Secure the brackets with T-15 screws.
System mount options 37