Removing The Brackets - HPE Edgeline EL300 Setup And Configuration Manual

Removing the brackets

Prerequisites
Before performing this procedure, make sure that you have the T-15 security screwdriver available.
Procedure
1. Power down the system.
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Remove all the cables routed through the cable management bracket.
5. Place the system on a flat, level surface.
6. Remove the cable management arm.
50 Associated hardware procedures