Hardware Options Installation; Power Adapter Option; Installing The Power Adapter Option; Sd Card Option Kit - HPE Edgeline EL300 Setup And Configuration Manual

Hardware options installation

This chapter provides detailed instructions on how to install hardware options.
For more information on supported options, see the product QuickSpecs on the website at:
http://www.hpe.com/info/qs
To view the warranty for your server and supported options, see Warranty information on page 78.

Power adapter option

The HPE Edgeline EL300 Converged Edge System supports the HPE EL300 80W 12 VDC power adapter option. This option is
supported only when the system is installed with the HPE EL300 12V DC Transfer board.

Installing the power adapter option

Procedure
Connect the power adapter to the EL300 system.
The installation is complete.

SD card option kit

The system supports installation of an 8 GB SD card.

Installing the SD card option

Prerequisites
Before you perform this procedure, make sure that you have the T-10 screwdriver available.
Procedure
1. Remove the SD port cover from the rear panel of the system.
20 Hardware options installation