Ism Network Port-Network Summary - HPE Edgeline EL300 Setup And Configuration Manual

The details for these tasks can be found in the HPE Integrated System Manager User Guide at http://www.hpe.com/support/
EL300-iSM-UG-en.
NOTE: iSM communicates with Remote Console over a private 16.x.x.x subnet. Do not connect the MGMT port, and by
extension iSM, to a subnet that has the same address space or network errors will occur.
1. Configure all iSM network connection settings that you intend to use on the Wired and Wireless Network pages:
Enable and configure the WiFI access point on the WiFi AP page. This method of access can only be used for initial
•
setup.
Configure a WiFi network connection on the WiFi page.
•
Enable and configure cellular access on the LTE page.
•
• Configure the Host Name Settings on the General page.
• Choose and configure LAN addressing on the IPv4 or IPv6 pages.
Click here for detailed instructions about configuring network settings.
2. Update firmware or add files to the repository on the Firmware pages. Download firmware updates from the HPE Support
Center at http://www.hpe.com/support/hpesc.
Click here for detailed instructions about updating the firmware.
3. Store an operating system image on your chosen installation media. You can install an operating system from a USB drive,
virtual USB (virtual media), SD card, or PXE.
NOTE: If you plan to use virtual media, mount the media before starting a remote console session or changing the host
boot order. An iSM Advanced license is required to use virtual media and the remote console. For detailed information
about the iSM Advanced license, see the HPE Edgeline Converged Edge System Licensing Guide at http://www.hpe.com/
support/EL-Converged-Edge-System-Licensing-en.
4. Update the host boot order in BIOS, iSM GUI, or by using the iSM CLI so that the next reboot of the host system checks
your chosen installation media first.
NOTE: HPE recommends setting the boot order on the iSM GUI Boot Order page. Use remote console (iSM Advanced
license required) to update the boot order in BIOS, or connect a keyboard, monitor, and mouse directly to the system. To
update the boot order using the iSM CLI, open an SSH command-line session to the IP address of iSM.
For the specific commands required to set boot order, see the HPE Integrated Service Manager User Guide on the HPE
Information Library at http://www.hpe.com/info/EIL.
Click here for detailed instructions about modifying the boot order.
5. Restart the host system and following the onscreen instructions to install the operating system.
Click here for detailed instructions about managing the system power.
6. Immediately after installing the OS, unmount the virtual media and then move SATA or NVMe to the top of boot order
(depending on where you installed the OS).
Click here for detailed instructions about modifying the boot order.
7. Register the product.

iSM Network Port-Network Summary

iSM provides the following options for network connection:
64 Configuration