Ipv6 Summary Details; Wifi Summary Details; Lte Summary Details; Configuring Host Name Settings - HPE Edgeline EL300 Setup And Configuration Manual

IPv6 Summary details

Address—The IPv6 address currently in use. If the value is blank, the IPv6 address is not configured.
•
• Address State—Indicates whether the address was supplied automatically or is static.
• Gateway—The gateway address in use for the IPv6 protocol. If the value is blank, the gateway is not configured.
Prefix Length—The subnet mask of the IPv6 address currently in use.
•
Link Local Address—The IPv6 address for the network segment.
•
Link Local Gateway—The IPv6 address of the local network segment gateway. If the value is blank, the gateway is not
•
configured.
Prefix Length—The subnet mask of the IPv6 link-local address.
•
IPv6 Address Policy table
This table shows whether IPv6 or IPv4 addresses are preferred.

WiFi Summary details

• SSID—The service set identifier which provides the name of the wireless network.
Strength—A measure of how powerful the signal strength of the connection is to the WiFi network.
•
Status—The status of the WiFi connection, connected or not connected.
•
• Security—The type of security in use on the WiFi connection.

LTE Summary details

• Enabled—Indicates whether LTE is enabled (True or False).
• APN—The access point name, which may or may not include an operator identifier.
Status—Indicates the state of the connection.
•

Configuring Host Name Settings

Use the General page to configure the Host Name and Domain Name. The host name and the domain name together
constitute the fully qualified domain name.
Procedure
1. Click Wired and Wireless Network in the navigation tree, and then click the General tab.
2. Enter the Subsystem Name (Host name).
The host name is the DNS name of the iSM subsystem. This name can be used only if DHCP and DNS are configured to
connect to the iSM subsystem name instead of the IP address.
3. Enter the Domain Name if DHCP is not configured.
4. Click Apply.
66 Configuration