Removing The Heatspreader - HPE Edgeline EL300 Setup And Configuration Manual

Mount the system on wall.
•
Mount the system on rails.
•
6. Connect the power cord to the system.
7. Connect the power cord to the power source.
8. Power up the system.

Removing the heatspreader

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-15 security screwdriver
• Phillips screwdriver
Procedure
1. Power down the system.
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Remove the antennas on the system.
5. Remove the installed bracket option.
6. Remove the security cover.
7. Remove the drive cage cover.
8. Remove the heat spreader.
56 Associated hardware procedures