Wireless Network Kit And Antenna Installation; Hpe Edgeline Wifi/Bluetooth Intel Ac9260 Option Kit; Installing The Wifi Card - HPE Edgeline EL300 Setup And Configuration Manual

Wireless network kit and antenna installation

The HPE Edgeline EL300 Converged Edge System supports remote management over wireless networks. This allows the
system to be deployed anywhere that is covered by WiFi or cellular signal.
Install the network cards first, then install the associated antennas. The system includes attachment points for two types of
antennas. Install one or both types depending on your configuration:
HPE EL Network WiFi option kit
•
HPE EL Network LTE option kit
•

HPE Edgeline WiFi/Bluetooth Intel AC9260 option kit

This option enables WiFi connectivity for the HPE Edgeline EL300 Converged Edge System. This option kit comprises of WiFi
network card and WiFi antennas.

Installing the WiFi card

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-15 security screwdriver
• Phillips screwdriver
Procedure
1. Power down the system.
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Remove the security cover.
5. Remove the drive cage cover.
6. Remove the heat spreader.
7. Remove the gap pad liner for the WiFi card from the heat spreader.
8.
Install the WiFi card.
28 Wireless network kit and antenna installation