Removing The Antenna - HPE Edgeline EL300 Setup And Configuration Manual

Removing the antenna

Procedure
1. Power down the system.
2. Remove all power :
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Place the system on a flat, level surface.
5. Locate the correct antenna slot.
6. Remove the antenna.
The antenna shown in the image may be different from your system.
Associated hardware procedures 49