Viewing The Network Configuration Summary; Network Configuration Summary Details; Ipv4 Summary Details - HPE Edgeline EL300 Setup And Configuration Manual

To access the network settings, view or edit the network settings on the following pages:
Summary
•
General
•
• IPv4
• IPv6
WiFi
•
WiFi AP
•
• LTE

Viewing the network configuration summary

Procedure
Click Wired and Wireless Network in the navigation tree.
The Summary tab is displayed.

Network configuration summary details

• Name—The name of the active iSM network interface.
• Host Name—The name assigned to the iSM subsystem. By default, the host name is iSM, followed by the system serial
number. This value is used for the network name and must be unique.
NOTE: You can configure the iSM host name on the General page.
MAC Address—The MAC address of the iSM network interface.
•
Permanent MAC Address—The unchangeable MAC address of the iSM network interface.
•
• FQDN— The fully qualified domain name of the system.
• IPv6 Default Gateway— When IPv6 is enabled, the gateway is the default IP address iSM uses to access the network.
When not enabled, this entry is blank.
• Speed (Mbps)—The speed of the wired network, measured in megabits per second.
• WiFi Network—The SSID of the WiFi network (if connected).
Cellular Network—The broadband wireless provider.
•

IPv4 Summary details

Address—The IPv4 address currently in use. If the value is 0.0.0.0, the IPv4 address is not configured.
•
Address Origin—Indicates whether the address was supplied automatically by DHCP or is static.
•
• Gateway—The gateway address in use for the IPv4 protocol. If the value is 0.0.0.0, the gateway is not configured.
• Subnet Mask—The subnet mask of the IPv4 address currently in use. If the value is 0.0.0.0, no address is configured.
Configuration 65