Connecting To The Ism Cli In A Serial Session; Ism Web Interface - HPE Edgeline EL300 Setup And Configuration Manual

3. Access the iSM web interface by entering the IP address in a browser window on a separate computer. Log in with the
default credentials listed on the system chassis tag.
4. Optional: Some management networks disable ICMP ping or other tools administrators might use to find the IP address. In
the absence of these normal tools, use a null modem serial cable and serial session to retrieve the IP address.

Connecting to the iSM CLI in a serial session

If ICMP ping or other tools are disabled on your management network, retrieve the IP address in a serial session.
Prerequisites
• System hardware unboxed and powered up
• Username and password noted from the chassis tag
• Null modem serial cable
• DHCP enabled management network
Procedure
1. Connect a null modem serial cable to the serial port on the system. Connect the other end to the system you are using to
configure.
NOTE: If your system was shipped with an HPE Edgeline Dual Serial Port daughter card, do not use serial daughter ports
for initial configuration of the system.
2. Start a terminal SSH session using a standard SSH tool like PuTTY. Use the following settings:
Specification
Baud rate
Data bits
Parity
Stop bit
Flow control
3. Log in by entering the default credentials shown on the chassis tag at the prompt.
4. Enter the relevant commands for showing or setting the network configuration.

iSM web interface

Use the iSM web interface to manage your HPE ProLiant EL300. You can also use the iSM CLI.
Browser requirements
The iSM web interface requires a browser that meets the following requirements:
JavaScript—The iSM web interface uses client-side JavaScript extensively.
•
This setting is not enabled by default in all versions of Internet Explorer. To check or change this setting, see Configuring
the Internet Explorer JavaScript setting on page 62.
• Cookies—Cookies must be enabled for certain features to function correctly.
Value
115200
8
None
1 (8 N1)
XON/XOFF
Configuration 61