Wall Mounting Option Kit; Installing The Wall Mounting Kit - HPE Edgeline EL300 Setup And Configuration Manual

The installation is complete.

Wall mounting option kit

The wall mounting option kit is required when mounting the system on a wall.

Installing the wall mounting kit

Prerequisites
Before you perform this procedure:
• Make sure that the preferred bracket option is installed on the HPE Edgeline EL300 system.
• Make sure that you have the following items available:
◦ Combo screws and wall anchors
◦ Phillips screwdriver
◦ Drilling machine
◦ 5/6 inch drill bit
Procedure
1. For hollow wall - Install the wall mounting base panel:
a. Identify the location for installing the mounting panel.
b. Place the wall mount base panel on the selected position on the wall and mark the screw locations.
NOTE: Align minimum one column, out of the three middle panels, to the internal wall stud.
c. Drill pilot holes on the marked screw locations and install the wall anchors.
Wall anchors are not required for holes aligned on the internal wall stud.
d. Install the top two screws halfway and hang the base panel.
e. Secure the base panel by tightening all the screws.
40 System mount options