Associated Hardware Procedures; Installing The Power Supply; Powering Up The System; Powering Down The System - HPE Edgeline EL300 Setup And Configuration Manual

Associated hardware procedures

This chapter describes the hardware operations carried out prior to and after installing or removing a hardware option, or
performing system maintenance or troubleshooting.
Before performing these hardware operations, review and observe system warnings and cautions.

Installing the power supply

Procedure
1. Connect the power cord to the power connector at the rear of the system.
2. Power up the system.

Powering up the system

If the system is connected to a power source, it powers up automatically. It needs to be powered up only after a manual
shutdown or after autopower off.
To power up the system, press the Power On/Standby button.

Powering down the system

Before powering down the system for any upgrade or maintenance procedures, you must back up critical system data and
programs.
Use one of the following methods to power down the system:
• Press and release the Power On/Standby button.
This method initiates a controlled shutdown of applications and the OS before the system enters standby mode.
• Press and hold the Power On/Standby button for more than 4 seconds to force the system to power down.
This method forces the system to power down without properly exiting applications and the OS. If an application stops
responding, you can use this method to force a shutdown.
Before proceeding, you must ensure that the system is in standby mode by verifying that the system power LED is off.

Mounting the system

The following kits are available to mount your system:
• Wall mounting kit
• Rail mounting kit
Before mounting the system, make sure that you do the following:
• Read the site requirements for the system:
System installation site requirements on page 18
• Read the safety and compliance information on the HPE website:
http://www.hpe.com/support/safety-compliance-enterpriseproducts
Associated hardware procedures 47