I/O Settings; Alarm Relay Output; Alarms - Honeywell Enraf Operation Manual

Entity
[Total]
[Upstream]
[Downstream]

2.3.6.3 I/O Settings

2.3.6.3.1 Alarm Relay Output

2.3.6.4 Alarms

Entity
[Alarm action]
Part No.: 44200004 - Revision 2
Controller Information
Description
Selects the Upstream Sensor to be
used as the "high" volume gate and the
Downstream Sensor to be used as the
"low" volume gate. This is the default
configuration
Selects the Upstream Sensor to be
used as the "high" volume gate and the
Midstream Sensor to be used as the
"low" volume gate
Selects the Midstream Sensor to be
used as the "high" volume gate and the
Downstream Sensor to be used as the
"low" volume gate
The Alarm Relay Output can be configured to be Energized (normally
closed) or De-energized (normally open).
The following alarm entity applies to Service Due Reminder and Machine Fault.
Description
With this entity the user can configure the
alarm behavior in case this particular alarm
will occur
The Service Due Reminder alarm is activated when the cycle count
reaches the threshold value programmed by the user at the Cycle Count
Threshold menu. The default setting for the Cycle Count Threshold
is 1000.
SVP Controller Operation Manual
Sensor used as
"high sensor"
Upstream Sensor
Upstream Sensor
Midstream Sensor
Value range
• <Disabled>: The alarm is ignored
• <Display>:
- Alarm shown on the display
- Alarm-indication output set to ON
- Next prover cycle will be allowed
• <Shutdown>:
- Alarm shown on the display
- Alarm-indication output set to ON
- Operation of further machine run cycles
are disabled until the alarm is cleared
- Still able to perform diagnostics via
RunProver Test or via Dashboard screen
from LAD
Sensor used as
"low sensor"
Downstream Sensor
Midstream Sensor
Downstream Sensor
2-13