Control Module (Bms) And All Battery Modules Install Into The Rack; Install The Mbms Into A 19' Standard Rack [If Configured]; Install The Ethernet Switch Into A 19' Standard Rack [If Configured] - Pylontech PowerCube-M1 Operation Manual

Lithium-ion phosphate energy storage system

Hide thumbs Also See for PowerCube-M1:

Table of Contents

To the Bottom

3.5.4 Control Module (BMS) and all Battery Modules install into the Rack

Dismantle the rack metal strip (on the left side and right side of the rack). After installed the



control module (BMS) and all battery modules need install these two stop blend back.

Install the buckle nuts. The position of nuts must meet the position of the control module (BMS)



and all battery modules.

Install the control module (BMS) and all battery modules in. Each module uses 4 screws to



fix it.

Install the buckle nuts. The position of nuts must meet the position of the MBMS.



Install the MBMS in. Uses 4 screws to fix it.



Install the buckle nuts. The position of nuts must meet the position of the Ethernet Switch.



Install the Ethernet Switch in. Uses 4 screws to fix it.



10 / 32

19PIMV0802

Table of Contents