Kara-Pullback Setup Safety Limits - L-Acoustics KARA MODULAR WST SYSTEM Rigging Procedures

® ® ® ®
KARA KARA
KARA KARA
M M M M O O O O DULAR DULAR DULAR WST DULAR
rigging procedures using rigging procedures using rigging procedures using rigging procedures using
VERSION 1.0
Rigging options 2 and 4 allow continuous bumper site angle setting depending on the relative heights between the
front and rear hang points (holes 1 and 17) as shown in Figure 69.
The configurations shown in Figure 69 are purely indicative.
ALWAYS refer to the mechanical data and warning indications provided in SOUNDVISION Software
(Mechanical Data section) [3.4] to verify the mechanical conformity of the loudspeaker assembly before
WARNING
installation.
Front extension configuration
and negative site angle
9.2.3

KARA-PULLBACK setup safety limits

The KARA-PULLBACK accessory attaches to the bottom enclosure of a KARA array to allow setting the site angle
down to -90°. However, this limit depends on the composition of the array as shown in Table 6.
ALWAYS refer to Table 6 before using the KARA-PULLBACK accessory.
WARNING
Table 6: Possible downwards site angles with KARA-PULLBACK
Number of KARA enclosures in the array
Number of SB18 enclosures in the array
-90°
Figure 70: 90° downwards site angle with KARA-PULLBACK
KARA_SRM_EN_1-0
® ® ® ®
WST WST WST SYSTEM SYSTEM SYSTEM SYSTEM
kara- - - - minibu kara
kara kara
Rear extension configuration
and 0° site angle
Figure 69: Continuous angle selection (option 4 examples)
Maximum array site angle
w w w . l - a c o u s t i c s . c o m
minibu
minibu minibu
Rear extension configuration
6 6
0 2
-90° -90°
and positive site angle
3
1
-90°
66 66 66 66