Laser Support Plate; Rubber Feet - L-Acoustics KARA MODULAR WST SYSTEM Rigging Procedures

® ® ® ®
KARA KARA
KARA KARA
M M M M O O O O DULAR DULAR DULAR DULAR WST
rigging procedures using rigging procedures using rigging procedures using rigging procedures using
VERSION 1.0
7.2.2

Laser support plate

Replacement kit and tools
KR MBUMPLAS, handheld inclinometer
5 mm hex bit, 7 mm hex key, KR LOCKBLUE.
1 ®
Available in the L-ACOUSTICS
Laser support plate replacement procedure
1. Put the M-BUMP on a flat horizontal surface (verify with the handheld inclinometer).
2. Remove the laser/inclinometer device from the laser support plate by undoing the four Torx
7 mm hex key).
3. Remove the old laser support plate from the KARA-MINIBU by undoing both hex screws (5 mm hex bit).
4. Mount the new laser support plate horizontally to the KARA-MINIBU (verify with the handheld inclinometer) by
driving two hex screws (thread-locker, 5 mm hex bit, 5 N.m/45 in.lb
5. Mount the laser/inclinometer device to the new laser support plate (laser lens towards the M-BUMP slits) by
®
driving the four Torx
7.2.3

Rubber feet

Replacement kit and tools
KR SB18iPAT, electric screwdriver with torque selector (N.m or in.lb
Rubber feet replacement procedure
1. Remove the old foot from the KARA-MINIBUEX by undoing the Torx
2. Mount a new foot on the KARA-MINIBUEX by driving a 35 mm Torx
in.lb ).
f
3. Repeat the procedure for all feet to be replaced.
KARA_SRM_EN_1-0
® ® ® ®
WST WST WST SYSTEM SYSTEM SYSTEM SYSTEM
kara- - - - minibu kara minibu
kara kara minibu minibu
1
, electric screwdriver with torque selector (N.m or in.lb
TECH TOOLCASE (refer to the TECH TOOLCASE Product spec sheet [3.4]).
bolts (T20 bit, 7 mm hex key, 3 N.m/27 in.lb
w w w . l - a c o u s t i c s . c o m
).
f
).
f
®
), T30 Torx bit, 10 mm hex key.
f
®
bolt (T30 bit, 10 mm hex key).
®
bolt (T30 bit, 10 mm hex key, 3 N.m/27
®
), T20 Torx bit,
f
®
bolts (T20 bit,
60 60 60 60