Array Disassembling Procedure - L-Acoustics KARA MODULAR WST SYSTEM Rigging Procedures

6.3.3

Array disassembling procedure

All along the procedure:
STRICTLY follow the sequence of the successive steps.
SYSTEMATICALLY verify that each BLP is fully inserted.
WARNING
For clarity purposes the loudspeaker cables removal procedure will not be described.
The loudspeaker cables will not be represented in the figures.
CAUTION
1. Detach the ratchet strap or other equivalent material from the stacked array.
2. Bring an empty KARA flight-case to the rigging location and remove the lid.
3. Separate the top KARA (KARA#3 for example) from the array by removing the four KARA#2 top
R-BLP from their link holes and re-inserting them into their storage holes.
4. Lift up and turn KARA#3 arms pointing up. Put KARA#3 into the flight-case tray.
Pay attention to the tray position: both wedges must slope upwards from front to rear.
WARNING
KARA_SRM_EN_1-0
KARA#3
KARA#2
KARA#1
Figure 42: Separating KARA#3 from KARA#2
Figure 43: Placing KARA#3 into the flight-case tray
w w w . l - a c o u s t i c s . c o m
KARA#3
Wedge
39 39 39 39