L-Acoustics KARA MODULAR WST SYSTEM Rigging Procedures page 22

® ® ® ®
KARA KARA
KARA KARA
M M M M O O O O DULAR DULAR WST DULAR DULAR
rigging procedures using rigging procedures using rigging procedures using rigging procedures using
VERSION 1.0
15. Close the four KARA#1 arms as follows (repeat on both sides of the enclosure):
a. Remove the front top R-BLP from its link hole, slide the front arm up, rotate it down, and lock it in place by
re-inserting the R-BLP into its storage hole.
b. Remove the rear top R-BLP from its angle hole, slide the angle arm so as to align the cursor with the storage
label, and lock it in place by re-inserting the R-BLP into its storage hole.
a.
L
16. Put the flight-case lid on.
KARA_SRM_EN_1-0
® ® ® ®
WST WST WST SYSTEM SYSTEM SYSTEM SYSTEM
kara- - - - minibu kara minibu
kara kara minibu minibu
Figure 20: Closing the KARA#1 arms
w w w . l - a c o u s t i c s . c o m
b.
L
20 20 20 20