Appendix; Lap-Teq Inclinometer Mounting - L-Acoustics KARA MODULAR WST SYSTEM Rigging Procedures

9 9 9 9

APPENDIX

APPENDIX
APPENDIX APPENDIX
9.1

LAP-TEQ inclinometer mounting

A laser support plate has been integrated inside the KARA-MINIBU for optional TEQSAS
inclinometer/laser device mounting. The LAP-TEQ is a remote control device which is part of the L-ACOUSTICS
TECH TOOLCASE (refer to the TECH TOOLCASE Product spec sheet [3.4]).
Laser support plate with
®
4 Torx screws and nuts
LAP-TEQ mounting procedure
Required tools
Handheld inclinometer (available in the TECH TOOLCASE), electric screwdriver with torque selector (N.m or in.lb
®
T20 Torx bit, 7 mm hex key, XLR3 cable.
Procedure
1. Put the M-BUMP on a flat horizontal surface (verify with the handheld inclinometer).
®
2. Undo the four Torx bolts on the laser support plate (T20 bit, 7 mm hex key).
3. Position the LAP-TEQ sensor on the laser support plate with laser lens towards the KARA-MINIBU slits.
®
4. Drive the four Torx bolts into the sensor and plate holes (T20 bit, 7 mm hex key, 3 N.m/27 in.lb
5. Connect an XLR 3 cable to the sensor.
6. Calibrate the sensor by following the manufacturer's recommendations.
KARA_SRM_EN_1-0
Figure 65: Laser support plate and LAP-TEQ inclinometer
w w w . l - a c o u s t i c s . c o m
Inclinometer mounted to
the laser support plate
®
LAP-TEQ
®
),
f
).
f
63 63 63 63