Pain Therapy, Hyperaemisation, Detonisation - Physiomed vocaSTIM-Master Operating Instructions Manual

Caution Take care that the electrodes are by no means touched after the
current is turned up!
(8) After treatment, an acoustic signal will be issued.
Turn the intensity down to 0.
(9) Remove the electrodes and rinse the viscose covers thoroughly.
Note The diffused quantity of the agent directly depends on the size of the
electrodes, the therapy time and the current intensity. During
galvanisation the maximum current intensity is 0.1 mA on 1 cm² of
active electrode area.
The time of each treatment must always be chosen according to medicament and
size of electrodes; one treatment typically lasts 10-30 minutes.

4.5.3 Pain Therapy, Hyperaemisation, Detonisation

The following current modes can be used for these modes of therapy:
G, UR, IG 30, IG
Treatment Procedure
(1) Prior to attaching the electrodes, make sure that the intensity control<6> is
turned down to 0!
(2) Attach the electrodes to the respective stimulation points.
(3) Select one of the above mentioned current modes from the display <3>, e.g.
.
FM
(4) Select the variable parameters (e.g. frequency, biphase, etc.).
(5) Set the therapy time.
(6) Set the time for treatment before turning up the intensity. Slowly turn up the
intensity with the intensity control <6>. Therapy time elapses.
Caution Take care that the electrodes are by no means touched after the
current is turned up!
(7) After treatment, an acoustic signal will be issued.
Turn the intensity down to 0.
(8) Remove the electrodes.
vocaSTIM - Master
®
50, FM.
Therapy
23