Removing An Smp Expansion Module And Cover - IBM xSeries 445 Installation Manual

Removing an SMP Expansion Module and cover

While installing options, you might need to remove one or both of the SMP
Expansion Modules. This section describes how to remove an SMP Expansion
Module from the server and how to remove the cover from the module.
Complete the following steps to remove an SMP Expansion Module from the server:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Open the top cover; then, remove the retention bracket or brackets from the
Figure 5. Removing the retention brackets and shipping thumbscrews
page 7.
external cables.
server.
a. Remove the shipping thumbscrews from the right side of the server.
Note: There are two shipping thumbscrews per retention bracket.
Retention bracket
removal handles
b. Grasp the retention bracket by the removal handles and lift it up and out of
the server. Store the retention bracket or brackets in a safe place for later
use.
Note: If there is one SMP Expansion Module installed, you will need to
remove the SMP baffle from the server; then, remove the retention
bracket from the lower SMP Expansion Module.
Retention bracket
SMP Expansion
Module
Shipping
thumbscrews
Chapter 2. Installing options
11