Smp Expansion Module - IBM eServer 445 xSeries Hardware Maintenance Manual And Troubleshooting Manual

Figure 44. Installing a DVD-ROM drive
6. If you have other options to install or remove, do so now. Otherwise, connect

SMP Expansion Module

The SMP Expansion Module contains the XceL4 system cache, DIMMs,
microprocessors, and voltage regulator modules (VRMs). This section provides
instructions for removing and installing the SMP Expansion Module,
microprocessors, VRMs, and DIMMs.
The following notes describe components in the SMP Expansion Module and other
information that you must consider when installing an SMP Expansion Module:
v Use two hands to install or remove an SMP Expansion Module. Do not allow the
v For the server to operate properly, there must be a minimum of one SMP
v An SMP Expansion Module must contain at least one microprocessor and two
v If there is only one SMP Expansion Module installed in the server, an SMP baffle
v When the minimum number of microprocessors is installed in the SMP
External removable
media bays
DVD-ROM drive
Tab
the power cords and turn on the server.
expansion module to come in contact with the center planar while lifting it out or
putting into the server.
Expansion Module installed.
DIMMs.
must be installed in place of the upper SMP Expansion Modules to ensure proper
cooling of the server.
Expansion Module, a microprocessor baffle must be installed in microprocessor
socket 4 to ensure proper cooling within the server.
DVD-ROM drive
eject button
Chapter 4. Installing options
97