Reinstalling An Smp Expansion Module And Cover - IBM xSeries 445 Installation Manual

Reinstalling an SMP Expansion Module and cover

After installing options in the SMP Expansion Module, you will need to reinstall the
SMP Expansion Module cover and reinstall the SMP Expansion Module in the
server.
Complete the following steps to reinstall the SMP Expansion Module cover:
1. Install the cover on the SMP Expansion Module:
CAM opening
Figure 19. Installing the SMP Expansion Module cover
a. Set the cover on top of the expansion module.
b. Extend the locking levers as shown in the illustration; then, let the cam on
the front of the cover fall into the cam opening on the SMP Expansion
Module circuit board.
Locking levers
c. Release the locking levers and align the rear of the cover with the rear edge
of the circuit board.
d. Press down on the cover until it snaps into place.
Chapter 2. Installing options
23