T8 (D8 Timeout); T9 (D9 Timeout); Q0 (P0 Timeout); Q1 (P1 Timeout) - Digi XBee SX 868 User Manual

AT commands
Specifies how long pin D7 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T8 (D8 Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin D8 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T9 (D9 Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin D9 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q0 (P0 Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin P0 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

Q1 (P1 Timeout)

This command applies to the XBee SX 868 RF Module.
Specifies how long pin P1 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
XBee® SX 868 RF Module User Guide
I/O line passing commands
150