Ct (Command Mode Timeout); E0 (Echo Off) - Digi XBee XTC User Manual

Parameter range
N/A
Default
N/A
Bytes returned
N/A

CT (Command Mode Timeout)

Set or read the Command mode timeout parameter. If a device does not receive any valid commands
within this time period, it returns to Idle mode from Command mode.
Use the CN (Exit Command mode) command to exit Command mode manually.
Binary command
0x06 (6 decimal)
Command type
Command mode options
Parameter range
2 - 0x53E2 [x 100 milliseconds]
Default
0xC8 (20 seconds)
Bytes returned
2

E0 (Echo Off)

Turns off the character echo in Command mode.
By default, echo is off.
Binary command
0x0A (10 decimal)
XBee/XBee-PRO XTend Compatible (XTC) RF Module User Guide
Command mode options
42