Table of Contents
Advertisement
Below is a screen shot of the EmBER viewer tool :
In the EmBER tree you go to :
"Device" > controller_dsp > network_trigger > parameters > e.g. "idx_1"
Setup GUI – EVENTS – Triggers – Sources – Parameters
Above is an example of parameter trigger sources. The phrase <multiple values> indicates that more than
one value of the parameter "Status" is bound to that trigger source :
If you click into the "Expression 1" field you see two
greenish marked entries. I.e. if one of these values is true,
"Expression 1" is true.
Setup GUI – EVENTS – Triggers – Configuration – Trigger Equation
To form a trigger you may logically combine two trigger sources :
Trigger
Source 1
invert
type
As a value you will receive the trigger name
In this example it is the first trigger named : "Movie".
Here you define a name for the trigger (Load Narrator).
The first source of a logical combination of two trigger sources.
[On / Off]
If the type of trigger allows an inverted operation it can be defined here.
[GPI / Hot Key, Network / Parameter / Event active / Trigger effective/
Bypass / Sync Lock]
46
V*AP
from the V*AP.
Advertisement
Table of Contents
