Switches And Jumpers For Configuration - junger d07 Operation Manual

3.3
Switches and
Jumpers for
Configuration
POWER INPUT
IEC mains input connector 85-264V, 50/60 Hz with integrated fuse
REMOTE
serial remote interface RS-422 (232)
connector: 9pin SUB-D, female
GPI
parallel remote interface
TALLY-out open relais contact
connector:
GPI-in +3,5...+30V potential-free
connector: 15pin SUB-D, female
SYNC
SYNC IN input for ext. sync signal (AES 3 format, 75 Ohm, unbal)
or video sync signal (blackburst, 75 Ohm, unbal) or
wordclock sync signal, TTL level, unbal
connector:
WCLK OUT output for word clock (system clock of d07)
connector:
DIGITAL IN
input for AES/EBU standard format
connector:
DIGITAL OUT
output for AES/EBU standard format
connector:
ANALOG IN/OUT
Analog input to 24 bit A/D-converter
Input floating balanced, XLR connector female
Analog output from 24 bit D/A-converter
Output floating balanced, XLR connector m
Some basic settings can be made by switches and jumpers at the internal circuit
boards of the unit. These settings can occur general changes for operation and should
made by qualified engineering staff only.
Internal
To set any internal jumper or switches it is necessary to open the unit.
PLEASE DO NOT MAKE ANY ALTERATIONS WITH THE MAINS STILL
CONNECTED TO THE UNIT!
Loosen the screws on the top cover and remove. Then you can see all jumper and
switches as shown in the drawing below. After setting of jumper or switches
reassemble the unit in opposite order.
25pin SUB-D, female
BNC socket
BNC socket
XLR female panel jack
XLR male panel jack