Extron electronics DTP2 T 211 User Manual page 36

ATTENTION:
• The extension of the firmware file must be
incorrect extension may cause the device to stop functioning.
• L'extension du fichier firmware doit être
mauvaise extension, l'appareil peut arrêter de fonctionner.
NOTE: The original factory-installed firmware is always available on the DTP2 211
unit. If the attempted firmware upload fails for any reason, the unit reverts to the
factory version.
On the
Add Device...
field (see figure 22,
Path
DTP2 T 211
DTP2 T 211
1
DTP2T211\dtp2t211_A_v1.00_081518.S19
3
2
Figure 22. Path to New Firmware File on the Add Device Window
10. If this is the only device uploading firmware, click
added to the section of the
Device
window closes.
If firmware is uploading to multiple devices, do the following:
a. Click (
3
Add Next
Firmware Loader
b. For each additional device that needs to be added to the
window, repeat steps 4 through 9, then click
c. For the last device, click
close the
Add Device...
.s19
.s19
window, the path to the new firmware file is displayed in the
).
1
Firmware Loader
). The first device is added to the
window, and the
Add Device..
Add Next
( ), instead of
Add 2 Add Next
window.
. Opening a file with an
. Si un fichier est ouvert avec une
( ). The device name is
Add 2
window and the
Add Device
section of the
Device
. window remains open.
Firmware Loader
( ).
3
( ), to add the device and
3
DTP2 T/R 211 • Remote Control 28