Extron electronics DTP2 T 211 User Manual page 15

Audio input (Optional)— (see
B
input into the transmitter via this female 3.5 mm TRS stereo connector (see
Audio Embedding (Transmitter)
NOTE: The analog audio input is in addition to the
digital audio that may be embedded in the HDMI
input (see the figure at right to identify the connector
tip, ring, and sleeve).
• A mono audio connector consists of the tip and
sleeve.
A stereo audio connector consists of the tip, ring,
•
and sleeve.
HDMI input — Connect an HDMI cable between this port and the HDMI output port (or
C
DVI port, with an appropriate adapter) of the digital video source.
Securing the HDMI Connector
NOTE: See
HDMI connector to the transmitter and the receiver.
DTP2 Out RJ-45 port — Connect one end of a TP cable to this RJ-45 port on the
D
transmitter. Ensure the opposite end of this cable is connected to the receiver DTP2
Input RJ-45 port (see figure 3,
Signal LED — This green LED indicates the unit is receiving a TMDS clock signal
•
on the HDMI input.
Link LED — This amber LED indicates a valid link is established between the units
•
on the DTP input and output cable.
ATTENTION:
• Do not connect these devices to a telecommunications or computer data
network.
• Ne connectez pas ces appareils à un réseau de télécommunications ou de
données informatiques.
NOTE: See TP Cable Termination and Recommendations
properly wire the RJ-45 connectors and detailed
Over DTP2 RS-232 and IR port — Connect a serial RS-232 signal, a modulated IR
E
signal, or both to this 3.5 mm, 5-pole captive screw port for bidirectional RS-232 and
IR communication (see
connector).
figure 2 on the previous page) Plug an analog audio
on page 19).
on page 10 to securely fasten the
on the next page).
C
RS-232 and IR Connector Wiring
DTP2 T/R 211 • Installation and Operation
Analog
Tip (+)
Ring (-)
Sleeve ( )
3.5 mm Stereo Plug Connector
(balanced)
on page 11 to
NOTES
on page 9.
on page 14 to wire the
7