Resetting - Extron electronics DTP2 T 211 User Manual

Select
•
previous page) if you want the computer to automatically connect to Windows
Update to search the web every time the transmitter or receiver is connected to this
USB port.
• Select
Windows Update to search the web at this time (for example, if the driver is already
on your computer).
3. Click
Next
The next screen of the Wizard opens:
Figure 12.
4. Select
figure 12,
5. Click
Next
NOTE: You do not need to insert an installation disc.
The PC locates the driver needed and installs it in the correct location on the hard drive.
6. When the
NOTE: The wizard opens only on the first occasion you connect the transmitter
or receiver to that USB port. The wizard reappears if you connect the unit to a
different USB port or if you connect a different piece of equipment, requiring a
different driver, to the same USB port.
7. Configure the transmitter or receiver as required using SIS Commands (see
Control

Resetting

Use the SIS command to reset the transmitter or receiver to its factory default settings (see
Reset on page 23).
Yes, now and every time I connect a device
(
No, not this time 3
( ).
4
1 1
Installing the Software Automatically
Install the software automatically (Recommended)
above).
1
( ).
2
screen appears, click
Completed
starting on page 20).
(see figure 11,
) if you do not want the computer to connect to
2 2
to close the wizard.
Finish
DTP2 T/R 211 • Installation and Operation
on the
2
radio button (see
Remote
18