Operations; Front Panel Features - Extron electronics DTP2 T 211 User Manual

Operations

Front Panel Features

DTP2 T 211 Front Panel
STATUS
INPUT
LINK
CONFIG
OUTPUT
A A B B C C
Figure 8.
A
B
C
D
SEND
POWER
DTP2 T 211
OFF
D D
Front Panels of the DTP2 211 Transmitter and Receiver
— Lights when the unit is receiving power, either locally or remotely (over the
Power LED
DTP cable).
Configuration port — Using a USB cable, plug a PC into the transmitter or receiver
via this front panel mini-USB connector for firmware updates (see
Front Panel USB Port on page 17).
Status LEDs
Input Signal — Lights when the unit is receiving a TMDS clock signal on the HDMI
•
input (transmitter), or any valid signal on the DTP In connector (receiver).
• DTP Link Status — Lights when a transmitter or receiver detect a sink signal from
a connected DTP device.
• DTP Output Signal — Lights when the transmitter or receiver establish
communication with the connected DTP2 or Legacy DTP device.
NOTE: The front panel LEDs are tied to the rear panel LEDs on the DTP2 port.
SEND POWER toggle switch — In a DTP2 transmitter to DTP2 receiver configuration,
set the toggle switch to the
enable sending remote power to the far end. Set the toggle switch to the
position on the DTP2 unit receiving power (see
switch configuration).
ATTENTION:
• The DTP2 211 device is configured to output power to DTP2 models only. If
connected to a Legacy DTP device, set the toggle switch to the
position. Failure to turn the power OFF will damage the connected Legacy DTP
device.
• Le DTP2 211 est configuré pour fournir une alimentation aux modèles
DTP2 uniquement. S'il est connecté à un autre appareil, veuillez positionner
l'interrupteur à bascule sur «
sur OFF, vous risquez d'entraîner la défaillance de l'appareil Legacy DTP
connecté.
NOTE: DTP2 transmitters and receivers are compatible with Legacy DTP products.
However, Remote Power must be configured properly. Failure to do so will result in
damage to the units.
DTP2 R 211 Front Panel
STATUS
INPUT
LINK
CONFIG
OUTPUT
A A B B
(SEND POWER) position on the powered DTP2 unit to
UP
figure 9
» (OFF). Si l'interrupteur n'est pas positionné
DOWN
DTP2 T/R 211 • Installation and Operation
SEND
POWER
DTP2 R 211
OFF
C C D D
Connecting to the
(OFF)
DOWN
on the next page for toggle
(OFF)
DOWN
15